ALCo RS-11 Replacement engine sounds by Johnnyboy (steam account name)

The ALCo RS-11 used a 1,800 horsepower ALCO type 251b v12 motor. This gives it the propper ALCo grunt. Other
locomotive applications of this motor include the RSD-12, RS-18(u) RS-36 and the FP(A/B)-4

-NOTE: THIS DOES NOT REPLACE THE HORN OR BELL, ONLY THE MOTOR

-The default startup sound was re-used, however, it transitions to the newer sound for idle and up.

-Installion is simple: just follow the corresponding steps.

-FOR THIS TO WORK YOU MUST HAVE THE STEAM EDITION OF THE VIRTUAL RAILROADS ALCo RS-11. However, I'm sure
this would work in the other verion as well with some editing (if done properly). I don't have the other version so I don't know.

-Disclaimer: As uploaded this file WILL NOT do damage to your computer. Any damage caused to your computer is NOT my responsibility. -Johnnyboy

-DO NOT re-upload this to other sites without my permission, and this item was intended for freeware DO NOT SELL IT.

-Lastly: This engine sound was made by using an existing one from Trainz Railroad Simulator by Dasnakke (Planet Auran account name)
All credit goes to him for the original files. I converted them for use in Railworks Train Simulator.

Installation:

1. Locate ProgramFiles(x86)\Steam\Steamapps\common\RailWorks\Assets\vR_Addon4\vR_Alco_RS11\Audio\RailVehicles\Diesel\RS11

2. Copy and paste ALL files from the sound replacement folder (not including the Readme-Instructions document) into the folder listed above.

3. Accept the overwrite (for the proxy's) and you are good to go with a new set of motor sounds.