Flatcars

[buzz456]

As I had problems to download the UKTS package from trainsimdev I found
https://www.treinpunt.nl/forum/download ... s;lid=4759
as an alternative.

I don’t understand what this has to do with this D/L?

[Railfan722]

That pack is a requirement for the flatcar set, since that’s where the base models come from. TSdev’s download library certainly isn’t the best, although it’s a lot better than sitting through the UKTS queue for the packs. Never realized that they made their way onto Treinpunt.nl as well.

[buzz456]

That pack is a requirement for the flatcar set, since that’s where the base models come from. TSdev’s download library certainly isn’t the best, although it’s a lot better than sitting through the UKTS queue for the packs. Never realized that they made their way onto Treinpunt.nl as well.

Where do these base model reside in my assets? I wasn't aware that I have them.

[Railfan722]

Where do these base model reside in my assets? I wasn't aware that I have them.

CHINA/RISC and CHINA/RWSO if the manual is correct. You may have them installed because Mike Calvin did a reskin of the same cars about 5 years ago.

[buzz456]

Where do these base model reside in my assets? I wasn't aware that I have them.

CHINA/RISC and CHINA/RWSO if the manual is correct. You may have them installed because Mike Calvin did a reskin of the same cars about 5 years ago.

My CHINA/RWSO only contains the Diesel ND5 and I don't have the other one and the flatcars loaded fine here. Just FYI.

[forlorn]

Hello I appear to have some kind of an issue with the 8 axle flatcar,
for some reason the front and back couplers are missing and it keeps falling into the ground and spazzing out

[Nitsujy12345]

I'm not sure if they're a requirement. The way I set the folders up, it SHOULDN'T be necessary, but I included that just in case someone has an issue.

[Nitsujy12345]

Hello I appear to have some kind of an issue with the 8 axle flatcar,
for some reason the front and back couplers are missing and it keeps falling into the ground and spazzing out

Someone else brought something similar to my attention. I think I know the issue. I’ll look into it and post an update tonight if that’s the case

[buzz456]

Just a FYI I changed the coupler assignment on the couple that the couplers didn't show up so they all referenced the pack you uploaded and don't need anything else. If you would like them holler and I'll send them to you to include in the update.

[Nitsujy12345]

Ah okay, thanks buzz. I’m not sure what might cause it to not work then...there was one point I was using it that it bobbed down into the ground every now and then, but only once, and never that bad. I’m not sure how to fix it

[Chacal]

I'm not sure if they're a requirement. The way I set the folders up, it SHOULDN'T be necessary, but I included that just in case someone has an issue.

Please notify me if the description in the Library needs to be changed.