Missing texture into the cab, RWA GP40-01

[jtousign]

missing texture.jpg

Quebec Gatineau.jpg

Hi everybody! I'm on the verge to complete a GP40 Québec-Gatineau repaint based on the VRC_RWA06 GP40. Lot of works by the way and finally I'm stuck on a missing texture inside the cab (see picture) on my repaint as well as on the basic model. Any help appreciated

[jtousign]

Another issue, the warning strobe (on the upper left side of the loco) doen't work.

[BoostedFridge]

Another issue, the warning strobe (on the upper left side of the loco) doen't work.

Does it work on the original VRC model?

[jtousign]

No, there is a switch on/off into the cab but nothing happens on either position. Same thing on either the RWA GP40 or my repaint.

[jtousign]

Missing texture.jpg

Here is a picture of the missing texture when clicking on the 8 key on the keyboard. However the odometer is showing up correctly in the game!**conf**!

[buzz456]

The missing textures in your first post are the numbers for the inside of the cab.

Screenshot_ ScaleRail Marias Pass_48.28122--113.61201_09-02-24.jpg

[jtousign]

gp402_cab2.jpg

Thanks Buzz, so could It be these numbers on the cab texture file? (see picture) Then what can I do to making them appear?

[buzz456]

That's not them. They should be VRC\RWA-GP40-01\RailVehicles\Diesel\GP30\RWASlug02\Engine\textures\cabnumbers
Here is a copy of that file if you don't have it. If you do we have another problem.

cabnumbers.zip

[jtousign]

Dear Buzz, many thanks, I had the cabnumber file into the slug folder but not in the GP40, I did a copy and paste of the file in the GP40 texture folder and that works fine!!