Markers Problem

[Shortliner]

So I'm having a problem with markers on my route, I can place them and on sidings, I can stretch them out to cover the length of the siding, However, I can't edit the name or delete them, and I can't re-select the destination marker once I place it.

Has anyone else had this problem?

[IIIIIREPOIIIII]

So I'm having a problem with markers on my route, I can place them and on sidings, I can stretch them out to cover the length of the siding, However, I can't edit the name or delete them, and I can't re-select the destination marker once I place it.

Has anyone else had this problem?

I do believe the same happed to me once saved the game closed RW and went back in then magic it worked ! did you try that ?

[Toldrabald]

Are you in scenario edit mode and try to change markers that were setup in route editor? That won't work. And deleting markers is never a very wise idea in my experience, has somehow they survive sometimes in the .bin files and can corrupt scenarios afterwards, even if they aren't used anymore.
In route editor I had them sometimes unselectable, but jumping to a far away distance (current tile + 2, so that one is in between) and back helped or changing the view point. Close up from above always seemed to help.

[Shortliner]

Are you in scenario edit mode and try to change markers that were setup in route editor? That won't work. And deleting markers is never a very wise idea in my experience, has somehow they survive sometimes in the .bin files and can corrupt scenarios afterwards, even if they aren't used anymore.
In route editor I had them sometimes unselectable, but jumping to a far away distance (current tile + 2, so that one is in between) and back helped or changing the view point. Close up from above always seemed to help.

I am in scenario edit mode, and so far I have no scenario using this one marker (destination), so I'm not worried about deleting them. My problem is that they don't show up once I place them, in scenario edit mode or in route editor mode. Also, restarting the sim doesn't help either. This is an ongoing problem.

[Popoff]

I have a similar problem in scenario edit mode. I can place a marker and stretch the end posts but the red center post does not show up, therefore I cannot name it or delete it. Also, the switch operator circles were not showing up in either the editor or the play mode. When I clicked on 'Tools>Display' in the upper left corner in the editor and then examined the properties panel in the upper right corner, I discovered that many (most) items were unchecked! Most importantly, the manual junctions and track markers. After re-checking them all, everything worked as it should. That's the good news! The bad news is that everytime I re-load RailWorks, I find that the same items are reset to 'unchecked'! When they are unchecked, they are unchecked in EVERY scenario. I have validated the RailWorks files on Steam, cleared the blueprint cache, and re-booted the computer. Nothing seems to help.

Are you guys experiencing this also?