Someone here was looking for a cheap surplus 44 Tonner for a mine?

[MadMike1024]

Sad. Downloaded again. Deleted the installed one and installed again.
Copy the engine file. same as before. i have no clue what to do next
Ton

Be sure to only copy the .geopcdx file from the installed pennsy engine folder to the army one, and no others. Do not copy the entire engine folder.

[AntonLchange]

I know that. after 3 trys i first will think it over.
Dont know what to do next.
Ton

[MadMike1024]

I know that. after 3 trys i first will think it over.
Dont know what to do next.
Ton

Try removing both locomotives using the utilities program. Re download the Pennsy, then install the Army loco and copy the file. See if a complete clean start helps.

[AntonLchange]

Sorry for the delay. but still no Ex-army 40tonner.
Ton

[charliechan]

Good Morning:

When this was first released I swapped out a power unit with RW_Tools and ran a scenario with the ex-army. Today I tried the same thing and nothing but the Pennsy will show up in the scenario. Deleted the folder and redownloaded and reinstalled but no change. I only copied over the GeoPcDx file.

[MadMike1024]

Good Morning:

When this was first released I swapped out a power unit with RW_Tools and ran a scenario with the ex-army. Today I tried the same thing and nothing but the Pennsy will show up in the scenario. Deleted the folder and redownloaded and reinstalled but no change. I only copied over the GeoPcDx file.

I found the issue... during the creation of the textures, somehow the compressed versions didn't get transferred. I'll create a patch file and set it up for you to download.