Coupler Questions

[Shayfan1]

I have a British payware car. Since it has buffers and the link and pin I swapped them for the buckeye couplers. However on one end the coupler is almost hidden the other is sticking way out. It is also too high. Is there a way to adjust this in the bin files. I have been looking but not having any luck.

[g_nash]

I have a British payware car. Since it has buffers and the link and pin I swapped them for the buckeye couplers. However on one end the coupler is almost hidden the other is sticking way out. It is also too high. Is there a way to adjust this in the bin files. I have been looking but not having any luck.

you will have to play with the bin , see here for info on the section that contains the matrix http://forums.uktrainsim.com/viewtopic. ... view=print

.

[Shayfan1]

Thanks for the link! I knew I had read about doing this but couldn't remember what site it was from. I guess I should have checked there first.