Railworks America

In addition to all of the other crap that you have to put up with when using the Scenario Editor, now this. I can't get anything done because I can't see to path the trains!

If you have a nVidia get newer drivers as they finally fixed the map view. If not you have to lower your graphics settings.

Will try that immediately. Now that I think of it, this wasn't happening last year when I was doing scenarios, but I was using an older Nvidia graphics card.

I had the same problem.I changed my Master detail to custom and it sorted it out...

More specifically, lower AA to something lower than a SSAA setting.

Ericmopar wrote:More specifically, lower AA to something lower than a SSAA setting.

Absolutely not! I dropped to much lunch allowance on that video card to not be able to max all settings out. Incidentaly, artimrj's answer was the winning one - the latest drivers cleared up the issue. Now if they could make the rest of the SE function without the need for a PhD in Programing and a minor in Forensic Computer Pathology just to make a train go from point A to point B.

JerryC wrote:

Ericmopar wrote:More specifically, lower AA to something lower than a SSAA setting.

Absolutely not! I dropped to much lunch allowance on that video card to not be able to max all settings out. Incidentaly, artimrj's answer was the winning one - the latest drivers cleared up the issue. Now if they could make the rest of the SE function without the need for a PhD in Programing and a minor in Forensic Computer Pathology just to make a train go from point A to point B.