Railworks America

I found this in another post:

Go via instruction: any part of the train must have hit the marker used in the instruction. If min. speed higher than 1mph is set, this must be maintained for the whole time the train is passingcoupling

If someone could show me how and where to place said marker, would be most appreciated. I can drive a train pretty good, but don't ask me about scenario creation.

Thanks,

Rob

Three little words: read the manual! In this case, the Timetable Editor users' manual . . . and do not ask me where to find it!

But Prof how will I find the outhouse there aint no directions on how to go via ROFLMAO

OldProf wrote:Three little words: read the manual! In this case, the Timetable Editor users' manual . . . and do not ask me where to find it!

Tom:

Three little words: I need help!

If the manual were written for mere mortals, I wouldn't need to ask.

I just want some simple, easy to understand guidance.

Rob

Reading this thread carefully should help you: viewtopic.php?f=8&t=10607&hilit=placing+track+marker . If not, try searching these forums yourself: there are plenty of tutorials here and also on YouTube.