Junctions in Scenario-Editor

[Nightc0re]

Is there a way to switch junctions in the Scenario-Editor?

Thanks in advance.

[Nightc0re]

I already found the answer here.

Thanks.

[rgarber]

I'm not following this. I don't see how the linked thread answers the question, which admittedly I didn't understand from the start. You first asked how to switch a junction in the scenario editor. Inwhich my first question was why would you want to? Then you said you found the answer in the linked thread but that suggests only how to save a manual switch setting for the start of a scenario. Or is that what you meant to ask all along? In either event that was an interesting discussion there as I didn't know you could do any of this. - Rich

[Nightc0re]

I'm not following this. I don't see how the linked thread answers the question, which admittedly I didn't understand from the start. You first asked how to switch a junction in the scenario editor. Inwhich my first question was why would you want to? Then you said you found the answer in the linked thread but that suggests only how to save a manual switch setting for the start of a scenario. Or is that what you meant to ask all along? In either event that was an interesting discussion there as I didn't know you could do any of this. - Rich

I meant, how to switch a junction-state at the beginning; and the other Thread answered this.
All things fine :)