Adriana County US Def2 1 Head 0T sign problem

[ironcat60]

Okay folks, I would like to place a Kuju RailsimulatorUS US Def2 1 Head 0T Signal in the route. The only problem is that the sign/number placard appears way above the signal instead of below it.

Now Marias Pass, which is required for Adriana County, uses what appears to be the same signals as the Kuju RailsimulatorUS US Modern signals. So it stands to reason the signal in question should appear with the sign in the proper place.

I have checked the bins for the signal from both the Kuju and Marias Pass Signals folder to see if there is any difference and I cannot spot any dissimilarities. Also I have dropped the bin from Kuju into the Marias Pass Signal Folder but get the same result, sign above the signal.

This error also appears on the US Def2 2 Head 0T and a similar error on the US Def2 Post 1 Head 0T Short where the signal head appears at the base of the post below the sign. So it basically mimics the behavior of the sign above the signal fault.

Anybody have any idea on how to correct this error?

[Chacal]

bump

[ironcat60]

Well I ended up using the UP Colorlights ADV Signal included in the game with a sign attached to the bottom as a replacement for the messed up looking signal.

When I feel the need to frustrate myself and have some spare time I will try and figure out why this route misplaces the sign above the signal when the signal appears normal in all other routes.

Thank you to all who have read this post. I appreciate your interest in this matter.

[buzz456]

Unfortunately like you all of us who read this post are as clueless as you about a solution.