Railworks America

For any of you Scale Rail users: what would be the best kind of track/crossing pad for a minor crossing in a yard?

UP is using the concrete pads over here, If you want them they are in RCAP v1.

Thanks I'll check those out.

You could use wooden crossing pads from either the Fort Kent to Eagle Lake Add-on, Colton & Northern Expansion Pack, or the Rascal & Cottonwood Expansion Pack.

CSXFECRailMan wrote:You could use wooden crossing pads from either the Fort Kent to Eagle Lake Add-on, Colton & Northern Expansion Pack, or the Rascal & Cottonwood Expansion Pack.

Bad idea. That just makes people buy more payware when it's not necessary.

buzz456 wrote:

CSXFECRailMan wrote:You could use wooden crossing pads from either the Fort Kent to Eagle Lake Add-on, Colton & Northern Expansion Pack, or the Rascal & Cottonwood Expansion Pack.

Bad idea. That just makes people buy more payware when it's not necessary.

Your right, Its better with Freeware so you dont pay, but realism it gets

Is it not practical just to raise the road, so that the tops of the rails are visible only? It doesn't exactly look like the world's most important thoroughfare.

From what I've seen in the wild, there should be just a few rough lumber pieces between the rails and gravel outside.
The rails can be a couple of inches over the road, no Porsche is going to go over that crossing.