TS 2017 Raildriver Interface V1.09

[cnbalasub]

I have a question about this installer that I download from the site of UKTrainsim. It's for Raildriver and I do have one but rarely used but will decide to use more from now on. OK the question is that do I have to install Macroworks 3.1 for my Raildriver? I am confused about this because I read from other sites that I don't need Macroworks 3.1 just install TS 2017 Raildriver Interface V1.09 into the program of Train Simulator 2017. Or do I have to have both with Macroworks 3.1 and TS 2017 Raildriver Interface V1.09. Also I am not sure if they have the program for North America locomotives or just the British locomotives. Let me now about this.

Thank you,

John

[AmericanSteam]

In order to run Raildriver interface Macroworks must not be running. Turn of autorun/startup for this. I have been using Raildriver Interface for a while with mixed results. Some 3rd party mappers do notwork well. Some DTM and MLWAudio mappers do not function properly. And it is not compatable at all with TSW.

[cnbalasub]

Thank you for your message and I think that I will stick with Macroworks 3.1 for my Raildriver. Unless someone tell me that TS Raildriver Interface V1.09 is better than Macroworks 3.1

Thanks,

John

[AmericanSteam]

Thank you for your message and I think that I will stick with Macroworks 3.1 for my Raildriver. Unless someone tell me that TS Raildriver Interface V1.09 is better than Macroworks 3.1

Thanks,

John

I will say that Raildriver interface by Cobra One has the ability to choose mappers and does offer more flexibility. Remember that you can use both. You just must disable one when using the other. I have both installed.