SD60E Norfolk Southern reloaded

[MartinVelozo]

Hi all

I come here to tell all, work to shape the SD60E of NS and its variants.
DTM provides the body and the blueprint.

[ColoradoRailfan]

Nice!

[_o_OOOO_oo-Kanawha]

Does it use the UP SD60 as a base model?
Then please correct the rear truck of the UP SD60M, it is the wrong way round. Do not make the same error again.

[buzz456]

Does it use the UP SD60 as a base model?
Then please correct the rear truck of the UP SD60M, it is the wrong way round. Do not make the same error again.

If you look at the picture you will see that the rear truck is correct.

[JohnS]

[MartinVelozo]

Hi.

Use frame and hood of SD50.

[OpenRailer90]

Looks excellent, it will come with Smokebox brakes and NSCD scenarios?

[_o_OOOO_oo-Kanawha]

Hi.

Use frame and hood of SD50.

Your SD50 still has no traction motors? You promised DTG an updated DRGW SD50, what became of that?
Then there is Dash8's? SD45's, GP50's in different paints, etc.
So far we have seen snow plows on the wrong end, snow plows too heigh, wonky handrails, trucks the wrong way round, missing traction motors, sand lines the wrong way round.

It seems to me you have many projects running parallel and therefor lots of chances to make errors that DTG doesn't notice because they don't seem to have USA knowledge in-house.

Are there any knowledgeable US players on your beta team that can point these errors out before sending the model to DTG?

We are glad to help good models turn into better models

[TheTeenageFoamer]

will It have flashing ditch lights like the prototype?

[Sibell]

I really really looking forward to this engine...uh I have so many repaint ideas for this beauty
Hopeful it doesn't need to long until it'll release. This is a definitely ''See it - Buy it !'' Cab looks sharp (and I hope with good template hihi)

[luifeldur]

[MartinVelozo]

Hi.

Use frame and hood of SD50.

Your SD50 still has no traction motors? You promised DTG an updated DRGW SD50, what became of that?
Then there is Dash8's? SD45's, GP50's in different paints, etc.
So far we have seen snow plows on the wrong end, snow plows too heigh, wonky handrails, trucks the wrong way round, missing traction motors, sand lines the wrong way round.

It seems to me you have many projects running parallel and therefor lots of chances to make errors that DTG doesn't notice because they don't seem to have USA knowledge in-house.

Are there any knowledgeable US players on your beta team that can point these errors out before sending the model to DTG?

We are glad to help good models turn into better models

Hi. I honestly do not understand, All our models have traction motor.
It was a long time ago sent the version update of SD50 DRGW to DTG. unfortunately they were not concerned about uploading to Steam.
Any other details you see if you can notify me please and check.
Thanks.

[TheTeenageFoamer]

if you don't know the dynamic brake grills in the front, the lower left corner (or right depending on the side) is a 45 degree angle. and the left side hand rail on the nose goes straight vertical

8728.1367710442.jpg

[FoodMonsterGuy]

What kind of horn will it have?

[buzz456]

What kind of horn will it have?

One that makes noise. Hopefully a RS5T.