Railworks America

OK so now that i finished the blueprint work now I come across the first of a few issues. I can click on the engine and it becomes a live engine no SBHH errors thats a good thing! But...

1.) trying to figure out why the back bogey turns this way when i click on the loco
2.) as you can see the D in the cricle represents where the driver icon ends up when i try to assign a driver to this unit. why is that?
3.) the HUD displays dynamic brake as the starting position for the throttle. yet I can turn off the dynamic brake but the throttle doesnt work. so it wont move. lastly the bogeys still do not pivot right. they are too rigid. I measured as accurately as possible but that doesnt do anything.

Would you be able to glean some information about this from the Dash 9?

I used alot of -9 info but when it comes to bogies and pivots I cant use those values since they arent the same. does this come back to the fact that my model may not be centered right in max?

I was able to fix the bogey issue it was a 3dsmax issue. didnt reset xform

The driver thingy is in that location on some other locomotives, you sure it doesn't work?