Railworks America Website

by **trainman251** » Sat Feb 08, 2014 10:38 am

Hello. I have been trying for quite some time to install the Ann Arbor route in to TS2014. Yes I am using the Utilities, and I copied the assets into the sim folder. But I cannot seem to get it into the sim. Everytime I open it and search, I cannot find it. Any recommendations to what I may be doing wrong or need to do? Thank you.

by **buzz456** » Sat Feb 08, 2014 12:21 pm

Where did you get it from?

by **trainman251** » Sat Feb 08, 2014 5:47 pm

I got it from here. The RWA site...

by **trainman251** » Sat Feb 08, 2014 5:47 pm

buzz456 wrote:Where did you get it from?

I got it from here. The RWA site...

by **buzz456** » Sat Feb 08, 2014 7:08 pm

Do you have RWTools? Look and see if it's listed. If not take a peek into your content file and see if f54c8890-cc8a-4e24-8a3c-8011900f4c58 is there. That is the Ann Arbor route.

by **JohnTrainHead** » Sat Feb 08, 2014 7:17 pm

What type of scenario are you trying to run? Does the route contain any scenarios? Check and see if it is listed in the editor.

by **NSrailfan6130** » Sat Feb 08, 2014 9:00 pm

I have installed the assets over and over and still can't seem to get the sky to show up, anybody else have this problem?

by **OlPaint** » Tue Feb 11, 2014 6:44 am

Ann Arbor Railroad route comes bundled with two free roam scenarios - "Temperance Yard Free Roam" and "Temperance Yard Transfer Free Roam". I found a third party standard scenario on the NERW website "NEAA-FHPG-001_End to end" by WackyHuman http://vnerrforums.com/rwforums/viewtopic.php?f=20&t=2598&hilit=NEAA that allowed me to drive a "Juice Train" all the way from end to end. However, it must have particular NERWPA assets installed to run correctly.

OlPaint

by **buzz456** » Tue Feb 11, 2014 8:52 am

NSrailfan6130 wrote:I have installed the assets over and over and still can't seem to get the sky to show up, anybody else have this problem?

No one else has mentioned this problem. Have you tried a different sky other than the default one?

by **NSrailfan6130** » Tue Feb 11, 2014 6:25 pm

Yes i have changed the sky but Iit just changes the slim line of sky you can see on the horizon, but the whole sky is still black as seen above

by **trainman251** » Tue Feb 11, 2014 10:40 pm

buzz456 wrote:Do you have RWTools? Look and see if it's listed. If not take a peek into your content file and see if f54c8890-cc8a-4e24-8a3c-8011900f4c58 is there. That is the Ann Arbor route.

Yep that's listed. Looked in Free roam and I still don't see it. Thanks I'll keep trying.

Railworks America Website

How to install the Ann Arbor route?

How to install the Ann Arbor route?

Re: How to install the Ann Arbor route?

Re: How to install the Ann Arbor route?

Re: How to install the Ann Arbor route?

Re: How to install the Ann Arbor route?

Re: How to install the Ann Arbor route?

Re: How to install the Ann Arbor route?

Re: How to install the Ann Arbor route?

Re: How to install the Ann Arbor route?

Re: How to install the Ann Arbor route?

Re: How to install the Ann Arbor route?

Who is online