Floating Caboose

[valleyforge]

Hi,

I have the NG Durango & Silverton route and made a consist with a Caboose on the end it, when i went to run it i found the Caboose was floating above the track, i went back into the WE and put in just the K27 loco and the Caboose, when i went to the track the Caboose was on the track as normal until i clicked on the K27 to run it, the Caboose was back floating again,

Any help would be appreciated as i have not come across this before with any stock,

Cheers,

Roger.

[arizonachris]

Roger, have you tried clearing the blueprint cache? Tools and Docs tab on the RW launch screen (BEFORE you click Start)

[PapaXpress]

There is a thread about this with a coal drag. I think Kali and someone else fixed it by tightening up the couplers. I wonder believe in another thread that changing over to the Britkits freeware couplers would fix this, but you would lose the ability to manual uncouple.

[valleyforge]

Hi,

Well i had already cleared the cache as i do every time i install anything,

Perhaps it might get a fix if others have the same problem,


Thanks for the replies,

Roger.