G'day fom Australia and a couple of questions please

[Polar61]

Hi all,
Hope this is a suitable place to post this...I have recently purchased TS2016, having already explored the RW3 space and have to say from the little I have run so far, TS2016 is excellent.
I have admired the Adriana County screenshots posted here and downloaded it from the Workshop hoping to get Marias Pass from somewhere. I now realise, that at least in Australia, I'm unable to find where to get Marias from.
Adriana County fires up OK in the scenarios and even though the scenery is there, the tracks are not. I suspect this is because I don't have Marias Pass? Short of finding Marias Pass somewhere is there any way I can get a work around for this?

I have bought the RWA Lakeside route and found that it is amazing but also want to get into Adriana County, if possible.

Also another question, how do I load my routes from RW3 into TS2016 or is this not possible?

Anyway, many thanks to all for this great site and I hopefully will have some screenshots to show in a little bit.

Kind regards
Polar61
Down Under

[buzz456]

Hi all,
Hope this is a suitable place to post this...I have recently purchased TS2016, having already explored the RW3 space and have to say from the little I have run so far, TS2016 is excellent.
I have admired the Adriana County screenshots posted here and downloaded it from the Workshop hoping to get Marias Pass from somewhere. I now realise, that at least in Australia, I'm unable to find where to get Marias from.
Adriana County fires up OK in the scenarios and even though the scenery is there, the tracks are not. I suspect this is because I don't have Marias Pass? Short of finding Marias Pass somewhere is there any way I can get a work around for this?

I have bought the RWA Lakeside route and found that it is amazing but also want to get into Adriana County, if possible.

Also another question, how do I load my routes from RW3 into TS2016 or is this not possible?

Anyway, many thanks to all for this great site and I hopefully will have some screenshots to show in a little bit.

Kind regards
Polar61
Down Under

Welcome to our little world. As far a RW3 routes any and all should run on 2016. All you need to do is copy and paste them (if you have them already in a RW3 folder) from the routes folder in your RW3 to the routes folder in 2016. That is in Content. As far as the tracks I'll have to do a little research. Maybe someone else has solved this problem and can jump in here.

[ErikGorbiHamilton]

Welcome! From what i know and was told the tracks are from the NS Coal District and the signals are from Marias Pass

[buzz456]

Eric is correct. The tracks are indeed from the NS Penn Coal route. You will be missing the signals which are from Marias Pass.

[buzz456]

Check your PM polar

[Polar61]

Gday buzz,
I can't seem to access my private messages...is this because I am a very new member?
Polar

[Polar61]

Hi Buzz
I can't seem to access my private messages...is this because I am avery new member to this site?

I noted the requirement for the Penn Coal route..is this the NS route which I got when I bought TS2016 through STEAM?

Cheers
Polar

[Polar61]

G'day
Thanks very much for the speedy replies. I take it the NS Coal route that came with my TS2016 is the NS Penn route you guys have mentioned? So if I have that as part of my TS2016 should the tracks be showing up then?

Thanks Buzz for your note about checking my pm, however when I go to use my private messages it says I have only just registered and may have to contribute more to use this feature.

Kind regards
Polar

[Polar61]

Apologies for the multiple posts.