Setting Up Sherman Hill Searchlight Signals
Posted:
Tue Jan 29, 2019 8:09 pmby RudyardRailroader
I am trying to update my Lakeside Route with Searchlight Signals from the Sherman Hill Route. Does anyone know how to set up the signal scripts to get them to function properly?
Re: Setting Up Sherman Hill Searchlight Signals
Posted:
Sun Feb 10, 2019 5:54 pmby trkrolesen
I am having a similar issue with setting up the SMM Searchlight signals on the route. My issues stems from getting all the links done in an area, then coming back to it, only to find the links are broken. If I fix those and check them- signals in another area break their links. I have tried various signals, but keep running into the same problems. I have also split and welded the areas around the signals to try and keep the links. Any suggestions would be great! I am running TS in 64 bit if that is any help.
Re: Setting Up Sherman Hill Searchlight Signals
Posted:
Sun Feb 10, 2019 6:10 pmby buzz456
It's been suggested by several people that until DTG puts out some kind of patch for the editor that one should use the 32 bit for route editing.
Re: Setting Up Sherman Hill Searchlight Signals
Posted:
Sun Feb 10, 2019 8:43 pmby trkrolesen
buzz456 wrote:It's been suggested by several people that until DTG puts out some kind of patch for the editor that one should use the 32 bit for route editing.
I hadn't heard there was a problem with the 64 bit editor... thanks!