Page 1 of 1
Existing Routes Not Listed
Posted:
Thu Feb 06, 2020 8:06 pmby harryadkins
My Ohio Steel (Dover and Masillon Divisions) route does not show up in RW Tools. My Ohio Steel (Dover Division) route is listed however. Any help with this issue?
Harry
Re: Existing Routes Not Listed
Posted:
Fri Feb 07, 2020 12:44 amby Chacal
Because it's archived in \Content\Routes\5a9ff10c-70c1-48d5-85d0-ff61b9f1ede3\MainContent.ap.
RW-Tools won't see it unless you extract RouteProperties.xml from the .ap file.
Re: Existing Routes Not Listed
Posted:
Fri Feb 07, 2020 12:18 pmby harryadkins
Thanks Chacal. I appreciate your help.
Harry
Re: Existing Routes Not Listed
Posted:
Fri Feb 07, 2020 12:20 pmby buzz456
harryadkins wrote:Thanks Chacal. I appreciate your help.
Harry
All you need to extract is the xml and it'll show so you don't need to load up your hard drive with the whole thing.
Re: Existing Routes Not Listed
Posted:
Fri Feb 07, 2020 1:44 pmby Chacal
Oh and by the way, RW-Tools has a function for extracting all RouteProperties.xml files.
Re: Existing Routes Not Listed
Posted:
Fri May 29, 2020 6:36 pmby LDWinn
I use TS-Tools. About 10 or 12 of my routes are not showing up. I have unpacked all .ap files both through TS-Tools and by using 7-zip. I have made all files read and write, using both TS-Tools and Windows. I have unpacked all scenarios the same way. But darn it if the last 10 or so routes purchased through Steam won't show up in TS-TOOLS. Am I forgetting something? I know I'm a little tired, but I've never had this issue before and have been using RW-Tools for years and years.
Hi,
When you add new routes to TS2020, you need to run the option Check Routes and Scenarios/Index Route Properties for any new routes to appear in either the Check Routes or Edit Scenarios areas. To make routes appear faster in the program, I had to index them to gain the extra speed.
Mike
Thank you Mike. That fixed it.
Lyric