Railworks America

Hi,
I have unpacked the assets files using the RW tools 7zip (which made them read/wright) and I can see the unpacked files in the proper files location all unpacked. but I do not see the UNPACKED ROUTE in the RW scenario editor. This applies to ALL the content that I try to unpack.
I have used this method before and did not have any problems.....????

I reloaded RW tools all over again and running the latest version.
I checked all of the paths and they are as they should be.
I can make a copy of a route in TS 15 and that shows up ok in the scenario editor.

Any suggestions on how to fix this????
Papa

Routes will show in RW Tools if the routeproperties.xml file is present in the route folder.

In RW_Tools, go to Find all .ap files, then click the buttons 'Select all MainContent.ap files' to select all of your routes, then click the preceding button 'Extract RouteProperties.xml from selected' and then all of your routes will appear in RW_Tools.

Note however, that although this does display all of your routes, if you wish to do any scenario editing etc, you still need to unpack the scenarios in question.

Mike