89' flat car with pipe

[buzz456]

I just got a chance to turn them into a child object and they are too long for two stacks of them to fit on the 89' flatcar.

Screenshot_Marias Pass_48.41350--114.33078_12-01-11.jpg

[thecanadianrail]

buzz the flatcar that you have shown in the picture is a 60' flatcar and not the 89', by the looks of it if you used the 89 they should just squeeze on there.

[NStrains]

Buzz thanks for trying out my curiosity! Those green and rusty colored pipes look really good though, adds a little character!

[buzz456]

buzz the flatcar that you have shown in the picture is a 60' flatcar and not the 89', by the looks of it if you used the 89 they should just squeeze on there.

Two sets still don't fit on the 89'.

[BKRR605]

buzz the flatcar that you have shown in the picture is a 60' flatcar and not the 89', by the looks of it if you used the 89 they should just squeeze on there.

Two sets still don't fit on the 89'.

Resize the pipes and then maybe they will fit

[buzz456]

buzz the flatcar that you have shown in the picture is a 60' flatcar and not the 89', by the looks of it if you used the 89 they should just squeeze on there.

Two sets still don't fit on the 89'.

Resize the pipes and then maybe they will fit

I never thought of that.

[jalsina]

buzz the flatcar that you have shown in the picture is a 60' flatcar and not the 89', by the looks of it if you used the 89 they should just squeeze on there.

Two sets still don't fit on the 89'.

Resize the pipes and then maybe they will fit

Resize just the Z axis. You may need slightly reposition the child after that

[NStrains]

jalsina, are you still working on any of the other loads from the other flatcar thread you posted the link to?

[jalsina]

jalsina, are you still working on any of the other loads from the other flatcar thread you posted the link to?

Not for the moment. I left those a while ago. But I can try to do something if needed.
What has been mentioned above of scaling different sizes of pipes in the same load can be somewhat complex to do, but not impossible. It could require several children. Not sure though.

[buzz456]

I made a child object from Michael's pipe load. Obviously I would need to get his permission before I could publish this but for playing around purposes I just need to set aside some time.

[NStrains]

Any additional loads for any of the flat cars are greatly appreciated! It never hurts to have more possibilities.

[jalsina]

Something missing in TS is a simple flatcar with six axles of the same type used by the Army.

[NStrains]

I can't say I've even seen many 6-axle flatcars.

[ZekTheKid]

Something missing in TS is a simple flatcar with six axles of the same type used by the Army.

Don't recall seeing those in real life.

[ET44C4]

Something missing in TS is a simple flatcar with six axles of the same type used by the Army.

Don't recall seeing those in real life.

I have seen a six axle flatcar in 2013. It was DODX #40277 on a BNSF manifest through Saginaw, TX.