Master Detail preset not saved ?

[Cardinal51]

Good morning all,

I am running TS2020 at 64bit on the MASTER DETAIL MEDIUM setting in the basic screen and MEDIUM setting in the advanced screen. But after clicking SAVE and returning to the same screen, or closing TS2020 and re-opening, the setting has reverted back to CUSTOM.

This does not make sense to me.

Do you guys and galls have any insight on this ?

Thanks

[buzz456]

Anytime you change anything in the advanced page it is now considered custom.

[Cardinal51]

Thanks for the help Buzz, but I am not sure I understand what you wrote.

So when setting the ADVANCED to MEDIUM it is normal that the ADVANCED shows CUSTOM after saving and checking again ?

So how does one check what preset is active ?


Edit - corrected typo in Buzz his name

[buzz456]

Thanks for the help Bizz, but I am not sure I understand what you wrote.

So when setting the ADVANCED to MEDIUM it is normal that the ADVANCED shows CUSTOM after saving and checking again ?

So how does one check what preset is active ?

If you don't set anything in the advanced settings then it should not say custom in the basic settings when you leave and come back.

[Cardinal51]

I go to> Settings > Advanced > Set Medium > Save. Then come back to Advanced and it is set to Custom.

Turns out that in my setup there is a buglet. When, after setting Medium, I move the mouse straight down (red arrow) to Save it all goes wrong. The setting jumps back to Custom. But when I do not move the mouse over the sliders (green arrows) to go to Save it stays all good. The setting stays Medium.

Untitled.jpg

[trev123]

When you first start the game and go into the graphics settings they are in the default settings but when you adjust something outside those default settings and save it they become custom.

[Cardinal51]

Thanks Trev. Weird thing was that I do not change anything. Tried to explain it in the post above.

Perhaps others have the same issue ? Just curious.