This is a set of Passenger Cars for the Western Maryland. I did these for a request posted by a member on the forums about a year ago.
Well with the release of the WM pack on Train Sim I decided to haul them out of storage and submit them to RWA as the WM pack has a locomotive that could be used for passenger service and the paint scheme matches these cars.
Auto-Numbering is enabled for the cars that are numbered.
Normally the WM passenger trains consisted of only chair cars and a baggage car. However if you desire to run a complete set there is a Coach, Baggage, Dinner, Lounge (Dome), Sleeper car, and Observation-End Car (Sleeper02). Sleepers are "named cars" with names that work similar to auto-numbering.
As the WM never had "named cars" I logically used the following naming format that reflects the operating area. Sleep car 01 has names representing towns with junctions and important points such as, Cumberland, Hagerstown, Emery Grove etc. The Sleeper car 02 (Observation-End) has names of Allegheny Vista, Allegheny Trail, Allegheny Highlands, Allegheny Heights. I based these names off the fact that the Allegheny's were a very important part of the WM's system and the fact that some of the foot trails where the WM once ran have Allegheny in their names.
Must have the original file, GX_Ltwt4pack_RW2, from G-TraX installed for this repaint to work. There are dependent GeoPcDx's and sub folders in that original file pack.
I hope these cars brings you many hours of railroading enjoyment as you watch the "Allegheny Vista" and "Emery Grove" sleepers roll by on the "Wild Mary" (WM's nickname).
Christopher aka IronCat60