Seligman Subdivision finally makes its way to TS2017 WIP

[OpenRailer90]

I suggest you switch out the old Kuju concrete track. It's just that bad

[krellnut]

I might do it later, but this will do until I get to Flagstaff.

Depending on what track you replace it with, the new track may have a different terrain height. So the new track may sit above the terrain, or below. Much better to switch to the new track this early in the build.

[buzz456]

Additionally if you switch the track out later on you can make a global height adjustment on the track if you need to with RWTools so it's no huge deal.

[cnbalasub]

Sorry to ask about your route. I subscribed your workshop route with no problem and show me in Workshop list with your route. But not in Career or Standard under Drive. So I decided to have a look at the program of RW_Tools to see what is the problem with this route. And here is the error below:

The Route Template listed in RoutesProperties.xml

D:\Program Files (x86)\Steam\steamapps\common\Railworks\Assets\Kuju\RailsimulatorUS\TemplateRoutes\Seligmansub2test.bin Could not be found.

I just checked to see in that folder with bin file and did not show any.

I am not sure what have to be fixed for this missing bin file. Will that be a possibility to send a bin file through private message. If you want an email then let me know.

Thank you,

John

[cnbalasub]

Daniel,

Thank you for your time to reply and I was very embarrassed myself to see that your route did show up in Quick Drive> Oh my goodness. But what scenario do I look for? Also what locomotive are you using this for two Quick Drive. Because it did not show up in RW_Tools for your train consists. So I am not sure which train is that used to run on your route.

Thank you,

John

[cnbalasub]

Daniel -- thank you for your reply but I am still confused with this part. I have no problem to access to Quick Drive and pick your route but how do I get the scenario show up for your route? I know you was telling me that you have two scenarios. Had no idea how to pick scenario after pick your route. May be you tell me step by step with Quick Drive setup to run your route with your scenario.

John

[cnbalasub]

Yes I did and still the same with no scenario from yours for this route. I am not sure what have I done with this? I did select Griffith as starting point and select Needles as end point but still ask me what equipment to run on your route. That's confusing with this. Yes I did watched the video that you put up the link for me to watch. Guess that I have to watch again to make sure what I have follow this or not. Let's me try one more time.

Thank you again,

John

P.S. If you can tell me what locomotive did you use for both scenarios? I am sure that will work with this route unless I am wrong.