Railworks America

I seem to have lost the slideshow screens for the TestTraK route. Here is what I get when I open or edit any scenario:


Then the scenario or edit session begins normally. Is there a place I can go to where I can enable or add in images for the opening slideshow? I saved the scenarios I created, then re-downloaded the route from Steam. That didn't help.
Any suggestions are welcome. in advance.

Best,
Marc

I see that every once in a while. I suspect that it has something to do with a web slowdown somewhere. Anyway, I just let it sit there while the scenario I've requested loads. The next time I try to load something it has usually gone away and the typical time-filling images fade in and out as they should. Just be patient.

I also get it occasionally, just ignore it and everything will still load. It is not a route thing, doesn't matter which route as it can happen on any one.

Thanks guys!

I thought I was doing something stupid (I'm good at that!!)

Hopefully it'll clear up soon. I don't recall seeing that before, but I guess there's always a first time. If patience is what it takes, then patience it will be.

Cheers!
Marc

That error popup has been showing up all day today for me in the TestTrak when launched inside Editor. But the Editor does finally launch...

OlPaint

fraserm wrote:Thanks guys!

I thought I was doing something stupid (I'm good at that!!)

Did we say you weren't doing something stupid? [ ]

Point taken, Tom.