Railworks America

Last night I was running a scenario on the Moscow Camdon 1920's route (Lumber out I believe)

I had to build a train in Camdon? and then couple a caboose to the train and then drive the train to Moscow.

At Moscow I had to uncouple the caboose and put the cars in the Moscow yard and then go back to pick up the cabosse.

Here's the problem:

I could not couple up to the caboose again. No matter how many time I back into the caboose (at less than 4 mph) and saw the couples close (in the coupler view) The couplers would not latch. As soon as I pulled away the caboose stayed right where it was.

Anybody know why it wouldn't couple. Or how I could have made it couple up to the caboose.

Thank for any explaination or help

Dave

I've had that issue before. Try saving your scenario and then exiting out of Railworks. When I reloaded the scenario, everything coupled as it should.

Thanks for the information. I would have never though of it.

Thanks again
Dave