Well, here's a new one. . .
Posted:
Fri Oct 21, 2011 11:49 pmby kcs_fan
I'm noticing many of my assets (buildings, plants, trees, etc.) are not showing up when I run or edit my custom routes. When starting editing, I slide the slider all the way up to 10 and some of the assets still do not show up.
When I run the scenario, I noticed that many of them do not appear, even when right on top of them. Anyone out there have any idea which setting I need to tweak???
Re: Well, here's a new one. . .
Posted:
Tue Oct 25, 2011 4:59 pmby kcs_fan
kcs_fan wrote:I'm noticing many of my assets (buildings, plants, trees, etc.) are not showing up when I run or edit my custom routes. When starting editing, I slide the slider all the way up to 10 and some of the assets still do not show up.
When I run the scenario, I noticed that many of them do not appear, even when right on top of them. Anyone out there have any idea which setting I need to tweak???
Reposted from earlier. Anyone got any ideas on how to fix this???
Re: Well, here's a new one. . .
Posted:
Tue Oct 25, 2011 5:06 pmby MontanaRails
Not sure if its related, but I've noticed this sort of thing happens when a default scenario is cloned (with RW Tools). I was running a cloned scenario on the HSC, and all of the switch ground throws would be invisible until you activated the switch, then they'd appear and stay put. I looked in the editor, and the detail level was the same as the default scenario. This is on a clean and fresh install of TS2012. No idea whats up!
Re: Well, here's a new one. . .
Posted:
Wed Oct 26, 2011 8:18 amby kcs_fan
Thanks so much for the reply. The problem is occurring with my custom built route. I didn't clone any of the others, I started from scratch. When I open the route, I check the slider and make sure it is set at 10. I've gone through and double checked the "resolution" of all of the items and using the slider thingy setting them all to 10 individually as well. When I close the route and come back later, none are where I set them.
