Railworks America

I wish to install the CN F3 driver and non driver livery from the RWA file library to the DTM F3 pack. Dropping the files into the DTM/F3 folder is pretty much straight forward but the instructions call for using TS_Tools to change some .geo files and rename them. I have been at this for a few hours now without success. I can only get the couplers to show when placed. Can someone who has the DTM F3, package this up for me or offer some help through PM? Instruction #4 is a bit unclear.

Check your PM.

This was interesting, I am not used to putting files within the AP. Most all of my other reskins everything has been outside the .ap file. That was my issue. I should be able to do the other version.
Thank you Buzz.