SD45 ‘SPSF’ LIVERY RE-SKIN PACK by Marleyman

[drjayyyy]

Hello. The above mentioned don't appear in the activity editor. The names appear but not the models. They were created back in 2014. Installed GeoPcDx etc.

[buzz456]

Do you see couplers or nothing?

[drjayyyy]

Hey Buzz. Thanks for the response.I get nothing.

[TheR62Fan]

Did you check if the cabview also has a geo file? Sometimes repaints will require you to copy that as well.

[buzz456]

The stock installation definitely doesn't work. I finally got this thing to show up (one of them) but so far the SP one crashes the sim when you click on is and one of the UP ones loads OK but won't respond to controls. You for sure have to put the CabView Geo in there to get anything to show up. Kinda surrendered on getting this to work for now. Maybe I'll try some more tricks later.

[buzz456]

Got it to work. Sheesh. What I did was take the stock SP copied and pasted it outside of the folder and renamed it SP Daylight 7399. Then I copied and pasted all the stuff in the SP DAylight 7399 texture file into that texture folder. Then I copied the SD45_SP_Daylight_7399 bin file and pasted into my new 7399 Engine folder. Then I went and copied the contents of the simulation folder and pasted it into the new 7399 simulation folder. Every time it asked if I wanted to overwrite I said yes. After I got done with that I pasted it back into the RailVehicles folder.

Screenshot_ ScaleRail Marias Pass_48.28104--113.61220_12-00-36.jpg

[drjayyyy]

Installed the cabview geo file and it shows up now .But just like you said it doesn't work. It crashed the sim etc. Oh well. Thanks for help Buzz and R62fan.

[buzz456]

Installed the cabview geo file and it shows up now .But just like you said it doesn't work. It crashed the sim etc. Oh well. Thanks for help Buzz and R62fan.

If you read my last post that is the key to get it all to work. Read da thing.

[drjayyyy]

Got it running ! Thanks.