DTM SD45-2 Repaints not working properly

[xxuntitledxx]

Hey all,

Just downloaded the NS DTM SD45-2 repaints from the repaint section.

I put the files in the right spot as per the read me, when the locos load in the sim I can see them as EMD SD45-2 NS and EMD SD45-2 ND as per the read me. When the loco loads it still has the Santa Fe Textures on the locomotives but with the NS numbering. Am I missing something or is there a bug in my sim?

Thanks.

[AmericanSteam]

Same issue here.

[buzz456]

Sometimes the simplest answer is the not so obvious answer. After frittering away a hour or so trying to figure out what was worded incorrectly or installed in the wrong place I went in and looked at the textures and lo and behold our intrepid re-painter had only changed the nmc version and not the nm version in the texture folder. The nm one was still in the ATSF livery hence all of us using high visual settings were seeing the ATSF one. I think both of you know how to fix this but if not just unzip and overwrite into the NS engine texture folder.

Hood_nm.zip

[xxuntitledxx]

Gotcha...thanks for the tip...I’ll have to keep that in mind for other ones too.Thanks

[AmericanSteam]

Thank you Buzz, that was it.