Railworks America

I have downloaded Rick Kfoury’s Central Vermont and Maine Central RS-11 (Harvest Gold) Repaints. The CV locomotives show up in-game no issue. The Maine Central locomotives on the other hand won’t appear in-game. I have copied all the necessary files per the instructions and have tried uninstalling and reinstalling them to no avail. I have also tried copy and pasting all the files (except the texture files) from the CV units to the MEC ones without any luck.
Any help to get the MEC units to appear in-game would be appreciated.

Thanks,

Logan

I have the same problem with the MEC RS11s and the GP7s show up as the base SAL locos but as he has dropped out for awhile I have left it alone and “fudged” round it. Repaint opportunities!

mindenjohn wrote:I have the same problem with the MEC RS11s and the GP7s show up as the base SAL locos but as he has dropped out for awhile I have left it alone and “fudged” round it. Repaint opportunities!

On the GP7 odds are without looking that there is a nm and then a nmc texture. Chances are only one of them got copied over to the new texture and your game is looking at the other one.

About the RS11 I just D/L and installed it and it works OK. The only thing you might get tripped up on is it says paste to cabview. It should say Cab. So you need to end up pasting four(4) Geos into the main RS11_MEC4 and one(1) into the 'Cab' folder. Look in the folders and make sure there are the proper number of Geos in each of these two folders. I'll post pictures if you need them.

Thanks Buzz on both points, I’ll check.

RS11s now working.
GP7s working, issue was that the Nmc files were the repaints but the Nm files original hence the problem, now resolved. Thanks again.

I made sure I copied and pasted the four Geo’s in the main folder and the other for the Cab. Still no luck.

Look carefully at the path on the top and make sure it's all the same except maybe what drive it's on and then make sure your folder looks exactly like this.