Railworks America

RS11 repaints refuse to show up anywhere. I have followed the instructions to the letter and am really stumped?? The dependent VR RS11 runs just fine.Any help would be greatly appreciated as those CP repaints look really nice!!
thank you

I'm not quite sure what you mean. They don't show up in the menu list or they don't show up in the game? If they are in the menu list but not in the game are the couplers showing up and nothing else or nothing at all.

They’re running fine on the Quarry branch of my new wip route as track testers. I installed by dropping the files into the vR Add-On 4 folder as per read me text.

Working fine here:

They show up in the list "QD" as per the instructions say, but when clicked on they physically don't show up. All appears to be loaded correctly. All other repaints etc run just fine.

OK!! I hate to admit this but I was using the wrong dependency--I was using the Lehigh Valley RS11 and not the PRR..Works just fine now, sorry for the confusion on my part..
thanks for your help, and maybe you could add in the instructions that the PRR RS11 is the dependency, again thank you and a very nice job!!

Sorry for the confusion I used the Leigh Valley to repaint the original which was the RMR repaint from M Duran from way back when. I'm not sure why you had to use the PRR dependency. I had to get the Leigh Valley just to do the repaint.


Pete
suzukisk

The Lehigh Valley wouldn't work, no matter what I tried--so I tried the PRR and the repaint worked right away--This is very confusing??

I don't even have the LV one.

Am I the only one who reads the “Readme” files is this a weakness in me, am I a poor example of a male or is it because I don’t know how to do it without reading the files?

So long as it's working now and we are all having fun. That's what it's all about

Pete
suzukisk

buzz456 wrote:I don't even have the LV one.

I recommend it. One of my favs. It's a great livery, good shading, shadow baking and weathering.