Problem with the locomotive

[cnbalasub]

Recently I run the scenario, [SD40V1] The Final Minutes on the route of The RaceTrack - Aurora to Chicago. All I see is the couplers of both locomotives. Why? Yes I have the files in Assets with RSC\SD40BnsfPack01\RailVehicles\Diesel\SD40-2\FURX_exBNSF\Engine\SD40_2FURX_exBNSF.bin also nd.bin too. All are there but how come not showing the whole locomotive just the couplers. Is there I can do to look into and see why the files are missing?

Your help would be appreciated.

Thank you,

John

[buzz456]

Can you take a screenshot of the engine file and post it here? I'm sure someone will spot the problem.

[cnbalasub]

I should have done with this in the first place to post my screenshot of the locomotive and here is now:

Screenshot_The Racetrack - Aurora to Chicago_41.85637--87.69092_19-03-28.jpg

[buzz456]

No the engine file, you know like go into the file folder and take a screenshot of the stuff inside the engine folder of that particular locomotive.

[cnbalasub]

Here is the screenshot of my Engine Folder below:

[buzz456]

You are missing the GeoPcDx file in there. You need to copy it from the default and paste it in here.

[cnbalasub]

First want to say thank you to you, Buzz and doesn't help with this problem to solve -- still the same with nothing else except the couplers. Yes I did copy/paste SD40-2_BNSF.GeoPcDx file from the folder in RSC > SD40BnsfPack01 > RailVehicles > SD40-2 > BNSF > Engine. Is that correct to copy/paste the GeoPcPx from that folder? If not, then tell me which GeoPcPx file to copy/paste?

Thank you again,

John

[buzz456]

In the installation instructions there is a folder called Other important Files. Read it and then run the SD40LeaserVol1GEO.vbs program that's in there. It should put the proper Geos in the proper place.

[cnbalasub]

Buzz -- You got a PM.

John