Railworks America

I know this has come up a few times over here, but it either gets solved automagicly, or the solution is not posted.

Currently there are no couplers showing up for anything.

This started happening a couple days after I installed DTM GP30 which uses the BritKits buckeye coupler, which I had already installed. I already swapped out the buckeye coupler folder with a backup I made before applying the BritKit, and I verified the files through Steam, but no luck. Any ideas?

Are you talking of the editor or of normal driving?
For me the couplers don't show up in the editor. After I go to drive the train, they again appear, just like magic.

In both unfortunately.

*ugh* go figure. I load it up last night and all is fixed.

It's all based on the position of your tongue, what phase the moon is in, and the location of cumulus clouds in the southern hemisphere.
Oh yea! I think your big toe has to be pointing in a NNE direction too.

That makes absolutely no sense. My computer desk faces due north and I .... was slouching NNE

BAH!

Hawk forgot to factor in the alignment of the planets.

And the effects of the super full moon.
Buzz