Railworks America

I installed the intermodal flatcars from G-Trax, but for some reason I'm unable to get the shipping containers to appear on the flatcars after I check their flyout box.

I have G-Trax "trains" and "articulated stacks" checked on the blueprint list. is there any other sources that must be checked for the containers to appear?

They should be in the articulated stacks folder. Look in railnetwork in the articulated stacks folder and make sure that they are there. If they are we'll see what else might be wrong.

buzz456 wrote:They should be in the articulated stacks folder. Look in railnetwork in the articulated stacks folder and make sure that they are there. If they are we'll see what else might be wrong.

Thanks for chiming in Buzz

I did a complete re-install, and whatever I did this time worked because the containers will now show up.

You made me go load this up to make sure it was working,,,,,,,soooo off for a trip from Frankfort to Lafayette.

Have a good run Buzz!!