Railworks America

I'm trying to repaint the NYNH SD40-2 but when I change the bins to look at the new textures, the repaint does not show up in game.

Has anyone else had this problem repainting the NYNH SD40-2?

With so little info, it sounds like issues with editing the bin files.

It's probably something within the bin file. I do the same method I always do on my repaints and the skins show up fine. This one, however, did not.

ZekTheKid wrote:It's probably something within the bin file. I do the same method I always do on my repaints and the skins show up fine. This one, however, did not.

That's not adding information to help anyone to solve your problem. You want to either post the bin or just zip it up and either post it here or send it to one of us and we'll see whats what. When thing you might take a quick look at is right near the end of the file under ScriptComponent you have to make sure your new name is there.

buzz456 wrote:

ZekTheKid wrote:It's probably something within the bin file. I do the same method I always do on my repaints and the skins show up fine. This one, however, did not.

That's not adding information to help anyone to solve your problem. You want to either post the bin or just zip it up and either post it here or send it to one of us and we'll see whats what. When thing you might take a quick look at is right near the end of the file under ScriptComponent you have to make sure your new name is there.

Here's the bins:
http://www.mediafire.com/file/ucsjxph0x ... SD40-2.zip
Make sure to put the cab and engine geos in the right place.

Tony,
I don't know what went wrong but your xml files were not converting properly to the bins. It took me a bit because I only discovered it when I opened the bin files with RWTools and there wasn't anything there. If you look they are only 1 kb. Here are some that work . As you can see they are quite a bit larger. Good luck with your re-paint. I look forward to it.

Thanks Buzz, I'll try them out ASAP.

I tested them on your re-paint and they showed up correctly.

The bins worked on the driver version. Tried the no driver version and it didn't work. I'll keep trying...

I'll recheck.