Railworks America

BNSFdude wrote:Did you check your gen field, engine run and control/fuel pump switch on the control stand?

Nitsujy12345 wrote:If you want, just use the one labeled with 'simp' to driver. It doesn't require any extra work like that to move

Driving this locomotive
-----------------------

Please see the GP15_cab.jpg picture for an annotation of the relevant controls.

<------------------------------------------------------------------------------------------>
< >
< The ENGINE CONTROL, FUEL PUMP and GENERATOR FIELD switches have been simulated. >
< IT IS IMPORTANT TO ENSURE THESE ARE ALL IN THE UP POSITION IN ORDER TO APPLY POWER. >
< The brake valve cutout has also been simulated. >
< IT IS IMPORTANT TO ENSURE THIS IS NOT IN THE OUT POSITION IN ORDER TO WORK THE BRAKES. >
< >
<------------------------------------------------------------------------------------------>

Use of Keyboard
---------------

This locomotive uses custom key mapping. This will not affect the default key mapping of the
simulator, including any customisations you may have made. The key mapping differs from
the default by:
A reduce power >
D increase power > ie MSTS style.

Note the "default" control locomotive uses the default key mapping.

Chacal wrote:Also it comes with instructions.

Driving this locomotive
-----------------------

Please see the GP15_cab.jpg picture for an annotation of the relevant controls.

<------------------------------------------------------------------------------------------>
< >
< The ENGINE CONTROL, FUEL PUMP and GENERATOR FIELD switches have been simulated. >
< IT IS IMPORTANT TO ENSURE THESE ARE ALL IN THE UP POSITION IN ORDER TO APPLY POWER. >
< The brake valve cutout has also been simulated. >
< IT IS IMPORTANT TO ENSURE THIS IS NOT IN THE OUT POSITION IN ORDER TO WORK THE BRAKES. >
< >
<------------------------------------------------------------------------------------------>


Surely you don't expect folks to read the instructions?!?



Use of Keyboard
---------------

This locomotive uses custom key mapping. This will not affect the default key mapping of the
simulator, including any customisations you may have made. The key mapping differs from
the default by:
A reduce power >
D increase power > ie MSTS style.

Note the "default" control locomotive uses the default key mapping.

OldProf wrote:

Chacal wrote:Also it comes with instructions.

Driving this locomotive
-----------------------

Please see the GP15_cab.jpg picture for an annotation of the relevant controls.

<------------------------------------------------------------------------------------------>
< >
< The ENGINE CONTROL, FUEL PUMP and GENERATOR FIELD switches have been simulated. >
< IT IS IMPORTANT TO ENSURE THESE ARE ALL IN THE UP POSITION IN ORDER TO APPLY POWER. >
< The brake valve cutout has also been simulated. >
< IT IS IMPORTANT TO ENSURE THIS IS NOT IN THE OUT POSITION IN ORDER TO WORK THE BRAKES. >
< >
<------------------------------------------------------------------------------------------>


Surely you don't expect folks to read the instructions?!?



Use of Keyboard
---------------

This locomotive uses custom key mapping. This will not affect the default key mapping of the
simulator, including any customisations you may have made. The key mapping differs from
the default by:
A reduce power >
D increase power > ie MSTS style.

Note the "default" control locomotive uses the default key mapping.