Page 1 of 1
Delaware&Hudson Repaints only couplers show up.
Posted:
Mon Feb 08, 2016 4:29 pmby Railroy19
I'm having a problem with these repaints showing up. I can only get the couplers to install.
I have the engine and cab Geopcdx files showing in the correct spot in the files but can't get the engines to show.
I have the NE gp-38's working ok by Justin Cornel.
Anyone have a solution to the problem?
Thanks,
Bob
Re: Delaware&Hudson Repaints only couplers show up.
Posted:
Tue Feb 09, 2016 8:06 pmby Railroy19
OK
Could anyone tell me if they have these repaints working.
I have tried all the tricks I know and all that shows up are the couplers.
Thanks,
Bob
Re: Delaware&Hudson Repaints only couplers show up.
Posted:
Sun Feb 14, 2016 12:53 pmby plovdiv21
It showed up and worked for me,are you sure you have the original JCornel model working and selected in the loco filter?
Re: Delaware&Hudson Repaints only couplers show up.
Posted:
Mon Feb 15, 2016 11:07 amby Railroy19
Hi plovdiv21
Thanks for the info. I thought no one had anything to say about these engines.
Not sure if I still have the original folders for Justins gp38
I have the repaints of the New England gp-38's working fine so I thought my folders were ok.
When I load these engines on the track the couplers show up but that's all. And then I can't delete the couplers off the route.
Not sure what's up with this.
Could you give me the file name I need or the location to download it again, I would appreciate it very much.
I may have the files somewhere in this computer.
Thanks again.
Bob
Re: Delaware&Hudson Repaints only couplers show up.
Posted:
Mon Feb 15, 2016 12:15 pmby buzz456
I ran the rwp using utilities and it all shows up just fine.
Re: Delaware&Hudson Repaints only couplers show up.
Posted:
Mon Feb 15, 2016 12:45 pmby Railroy19
I did the same thing Buzz and have no idea why they are not showing up. I must have a file from the original GP-38 missing.
I may have lost the original files when I had computer problems. Have no idea how to get those files back again.
I can't delete the couplers from a route even when editing a route once they are installed they are there for good!
Re: Delaware&Hudson Repaints only couplers show up.
Posted:
Mon Feb 15, 2016 2:59 pmby buzz456
Railroy19 wrote:I did the same thing Buzz and have no idea why they are not showing up. I must have a file from the original GP-38 missing.
I may have lost the original files when I had computer problems. Have no idea how to get those files back again.
I can't delete the couplers from a route even when editing a route once they are installed they are there for good!
If you own RWTools you can go into the scenario editor and the item will show up there as a consist even though it's invisible in the game and you can delete it there.