Any problem with Cajon Ethanol Haul on Cajon Pass route??

[cnbalasub]

I want to check with anyone else who have the same scenario -- Cajon Ethanol Haul [GWD125] to run on this route of Cajon Pass. I can't run this because of the errors. I have the Cajon Pass route, MP rolling stock also UP SD70ACe Heritage locomotives. Anyway here is the error message below:

Consist Builder -- Can't load rail vehicle -- EMD SD70 UP Denver Rio Grande

Consist Builder -- Can't load rail vehicle -- EMD SD70 UP Chicago Northwestern

Broken Consists -- Modified.

I did check this scenario in the program of RW_Tools to see the error of this scenario and show me all good. I am not sure what is wrong with this scenario.

Let me know about this.

John

[trev123]

You need this. http://store.steampowered.com/app/222596/

EMD SD70ACe in six Union Pacific ‘fallen flag’ heritage liveries

◾ Liveries include Denver & Rio Grande Western, Missouri Pacific, Western Pacific, Missouri-Kansas-Texas, Chicago & North Western, and Southern Pacific

[cnbalasub]

I have those already installed three days ago but for some reasons the scenario cannot read the UP SD70ACe Heritages to run the scenario. That's strange.

Guess that I have to uncheck the payware locomotives and scenario ( from workshop in Steam ) and then install again.

Thank you,

John

[cnbalasub]

My mistake that I do NOT have the set of UP SD70ACe Heritages but got them now. Will let you know that how it turn out with this scenario.

John

[cnbalasub]

Unfortunately this scenario with " Cajon Ethanol Haul " on Cajon Pass Route had a minor problem and I have no idea what this mean to me? I am very new with this program of Train Simulator 2016. Anyway here is the error message that I wrote down from showing on the monitor screen of this scenario.

Scenario failed to load

Driver UP 1989 at Lat. 34.88185 Long. -116.97301 Route is blocked.

I chose to exit this scenario instead edit because I have no idea about this. I am not sure if RW_Tools can fix this or not. I did posted my message over steam community discussion forum about this as well so far closer to an hour no one reply to my message over there.

Explain to me what is " Route is blocked " ?

Thank you for your patience with me.

John

[trev123]

When you look at a scenario in the Workshop it usually tells you what DLC you need and in this case Marias Pass, Sherman Hill and Cajon Pass plus the Heritage pack. If you have problems with a scenario always check the comments which there are 56 of and see if someone else has had the problem, if not you can leave a comment and the author of the route will more than likely reply. I will give this scenario a go. That error message means a loco has blocked the track at those coordinates. Write them down then go into the TS scenario editor and select that scenario and enter those coordinates in the middle top of the screen press enter and you should end up at that location. I see that some workshop scenarios that were written for TS2015 are now broken in TS2016.

I have tried the scenario but get the same error but says Many Failures you can bypass this by pressing the F2 key and click on save and the scenario will work. Pretty old scenario, made for TS2014. Might pay to subscribe to newer ones.

I left a comment about the error and now the scenario has been removed from the Work Shop.