Railworks America

I am just getting back into playing TS after a couple of years hiatus. I had been playing a Work shop scenario and saved it's progress and exited TS. When I restarted TS and selected the resume button for the Work Shop scenario, I got a black screen with a distorted PF4 control board at the bottom. I had to restart my computer to get out of it.

Has anyone else had this problem, or is it unique to me?

The scenario is Rigby Local Part 4 Sprague Energy

I tried to take a screen shot but could not because TS was locked up.

I tried resuming a standard scenario and it resumed with not problem. I then tried resuming a different Rigby Work Shop scenario and it also resumed with no problem.

I then played Rigby 4 from the start and when the scenario loaded, I got the broken consist pop up. I selected the edit button and then closed the editor with out making any changes and the scenario ran fine.

I completed the entire scenario, but created a save point at the exact same place I had when I played it earlier.

After completing the scenario, I went back and tried the resume button and got the same black screen and distorted PF4 control panel that I had the first time.

I do not understand why this scenario cannot be resumed.

I went back in and played Rigby 4 again and this time created a save point at a different place.

When I exited the scenario and went back in using the resume button, the scenario opened and ran with no problem.

???????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????

Ain't computers wonderful.