SD40T-2 Set Installation problem? With link to content in RWA.

[Ericmopar]

With the new skins installed, you may have to enable Donner Pass in the scenario or route in question to use the locos. Or you may have to enable whatever asset folder the install process created in the route or scenario.

[gtrtroger]

What Ericmopar said.....
So many folks forget this step....

[ZeroCNReaper]

With the the new skins installed, you may have to enable Donner Pass in the scenario or route in question to use the locos. Or you may have to enable whatever asset folder the install process created in the routed or scenario.

In the video it showed that i had the Donner Pass assets active in the fly out box menu.

I used the same route even though it was acadamy to test to see what i had installed worked.

I put the set directly into the Donner Pass route in the default SD40T-2 folder when before i had it set as a stand alone folder in the RSC folder which it didn't work then either.
As having two Donner Pass folders in RSC seemed unnecessary.

[/quote] you may have to enable whatever asset folder the install process created in the routed or scenario.

I installed everything manually as for whatever asset folder the install process created in the routed or scenario i am unaware of since there was no indication that it did so and i would not know where to look.

In response to gtrtroger
I have 4314 hours on TS16 and a good portion of that was spent in editing (Route building) and freeroam.
I only recently started trying the Career scenarios and standard scenarios.

[ZeroCNReaper]

Anyone have a solution on me being able to get this set to work?

[BoostedFridge]

I just rewatched your video again, and noticed that you have not copied the 'Cabview' folder from the default folder into the reskins folder. I doubt that would make the difference in the reskins not appearing in game, but at this point I'm almost out of guesses. Try copying the Cabview folder as per the instructions.

[ZeroCNReaper]

I just rewatched your video again, and noticed that you have not copied the 'Cabview' folder from the default folder into the reskins folder. I doubt that would make the difference in the reskins not appearing in game, but at this point I'm almost out of guesses. Try copying the Cabview folder as per the instructions.

I will try it and see if it does the trick.
Got my fingers crossed at this point.

[ZeroCNReaper]

I am having tears of joy right now (not really) but it finally works.

Thank you everyone who helped me in getting this set to work correctly.
Was honestly getting frustrated with it and if it didn't work i was going to drop it and thankfully i don't have to.
Again thank you guys you were very helpful.

I think the thing that was making it work incorrectly originally was that it was in a standalone folder instead of putting it into the default SD40T-2 folder despite adding the needed files.
Just forgot to add the cab view folder this time.

Again thank you.