coupling question

[LionelDave]

Last night I was running a scenario on the Moscow Camdon 1920's route (Lumber out I believe)

I had to build a train in Camdon? and then couple a caboose to the train and then drive the train to Moscow.

At Moscow I had to uncouple the caboose and put the cars in the Moscow yard and then go back to pick up the cabosse.

Here's the problem:

I could not couple up to the caboose again. No matter how many time I back into the caboose (at less than 4 mph) and saw the couples close (in the coupler view) The couplers would not latch. As soon as I pulled away the caboose stayed right where it was.

Anybody know why it wouldn't couple. Or how I could have made it couple up to the caboose.

Thank for any explaination or help

Dave

[harryadkins]

I've had that issue before. Try saving your scenario and then exiting out of Railworks. When I reloaded the scenario, everything coupled as it should.

[LionelDave]

Thanks for the information. I would have never though of it.

Thanks again
Dave