I am trying to load newly installed USRA Mikado with limited luck. I have just purchased the 4-8-2 and it is just fine. I uninstalled all other models and downloaded the updated same.
Now if I try to load a Mikado into a scenario (Any route) I just get couplers (from a specific view only, otherwise invisible) on some and not others, which load OK.
The 2-8-2 with a suffix of dc or sc in the name as well as anything with GN, GN2 or CBQ wont load visible. Same with tenders, not visible.
Any help please.
Marita T.
USRA Mikado loading issue
First unread post • 1 post
• Page 1 of 1
USRA Mikado loading issue
by render2017 » Thu Oct 09, 2014 12:04 am
You do not have the required permissions to view the files attached to this post.
My father said "Rember nine out of ten people around you are stupid, and I am not sure about you either" RIP . . .
- render2017
- Posts: 91
- Joined: Mon Feb 16, 2009 4:44 am
- Location: Kingaroy Queensland Australia
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest