Signal Held at Danger

Tips and discussion about scenery creation for RailWorks.

Signal Held at Danger

Unread postby benny335 » Sun Oct 22, 2017 6:06 pm

Is there anyone out there who might know of a way to either modify a CORA signal so that it is always held at danger until you TAB it or maybe if something like that exists already? I'm working on a route where the signals are tied to level crossings and the TAB-ing idea is the closest I could get to tying the signal to the level crossing.

Thanks!
benny335
 
Posts: 42
Joined: Tue Jun 30, 2015 12:20 pm
Location: Escondido, CA

Return to Scenery Design

Who is online

Users browsing this forum: No registered users and 2 guests