EMD SW1200 Switcher in NERW, HC & CSX liveries. Five units. RW3 models.

This uses the new update to RW3 models. You should uninstall any older versions you have.   You must have the Britkits SW1200 freeware installed. You can find it here http://dickyjim.com/diesel.html Kit 05 the SW1200.

Install the RWP file with the Railworks Package Manager. These units will be installed to Railworks\Assets\Britkits\EMD\RailVehicles\Diesel\SW1200\. Their folder names are:

NE_Black NE_Black-dirty NE_HC NE_CSX NE_CSX-dirty

 In the scenario editor it will be prefixed with NE - to make it easier to find, like this NE - EMD SW1200 Black & a dirty version. The CSX also has a dirty version, the HC does not.

To use in a scenario you must have the Britkits and EMD turned on in the object browser . Two additional engine files also also included that has no driver character and one with the No Notch throttle. These have an NC & NN in the display name, as in NE - EMD SW1200 NC, standing for No Crew and NN for No Notch. The brakes have been updated.

You should have no problems with this unit as it is merely a repaint of the Britkit freeware engine, if you do, you can post a message in the support forum at www.vnerrforums.com/rwforums/

This package is released as freeware, you can do whatever you wish with it EXCEPT make money with its use. It is FREE! Dick Cowen owns all copyrights.

Bob Artim

Addendum:

The brakes were adjusted using RW_Tools settings. The internal name has been corrected from just being x-sw1200 for each unit. An engine information page has been added so it shows up when you Drive by Train.