Stevens Pass junctions

Discussion about RailWorks route design.

Stevens Pass junctions

Unread postby 901meister » Tue Aug 07, 2018 3:30 pm

I am starting work on a new route and having some problems with the Stevens Pass track. I have created a Track Rule that uses the Stevens Pass tracks and I replaced the manual junctions with the ones from PennCoal. The new junctions do not show in the editor. The turnout is normal in all other ways, just no visible switchstand. I have replaced switchstands and motors on other routes and have never had this problem. Any ideas?
901meister
 
Posts: 2
Joined: Tue Aug 07, 2018 2:19 pm
Location: Georgia, USA

Return to Route Design

Who is online

Users browsing this forum: No registered users and 3 guests